Press Plant | General Maker of Terminal Block, Osada Japan

Japanese Site

Press Plant

The press plant went into full-fledged operation in July 2015. In addition to producing metallic parts for terminal blocks, the plant actively pursues R&D into new products and technologies.

Refer to this section for the list of equipment used in the press plant.

  • A device that performs tapping (M2 to M10) at the same time in the press process(1).
  • A device that performs tapping (M2 to M10) at the same time in the press process(2).
  • A device that performs tapping (M2 to M10) at the same time in the press process(3).
  • Equipment for processing copper and brass materials with a thickness of 4 mm while wound on a reel.

List of equipment used in the automatic lathe plant

Equipment Number
Crank press(45t – AMADA) 1
Crank press(60t – AMADA) 4
Crank press(60t – AIDA) 4
Double crank press(110t – AIDA) 1
Leveller feeder(for brass 4mm) 1
Roll feeder(200mm) 4
Servo Press(200t – AMADA) 1
Servo Press(80t – AMADA) 1
Uncoilers leveller 5
Leveller feeder(for brass 3.2mm) 10
Roll feeder(400mm) 1
bubble polishing machine 1